Cylindrical ring gage calibration is a critical process for anyone looking to use these pieces of equipment in their inspection services. They can be used as Go/No-go gages to inspect the outside diameter of a rod or shaft. The United States manufactures cylindrical ring gages per ASME B89.1.6. The ATS calibration lab is can handle X, XX, XXX, Y, Z, and ZZ tolerances as well as any customer tolerances.
The Standards Calibration lab is an environmentally controlled room set at 68° F with a +/- 1-degree variance. We also keep this room humidity controlled at 30-55% resting humidity. All gages are cleaned and set in the room to stabilize at temperature for a minimum of 24 hours before testing to ensure accurate readings.
All calibrations tests and results are available around the clock 24/7 online for your convenience. At ATS, we are committed to quality assurance by holding the following certifications and accreditations: ISO 9001, ISO IEC. 17025, ANSI/NCSL, 10CFR50 Appendix B, Z540-1, and 10CFR Part 21. Contact Applied Technical Services for any inquiries on cylindrical ring gage calibration.