Gage Calibration

Fixed Gages, External Gages, and Internal Gages

ATS has the capability to perform calibration on a wide range of Setting Standards and Working Gages. ATS has the ability to calibrate classes XXX, XX, X, Y, Z, and ZZ toolmakers tolerances as well as customer’s tolerances. Internal measurements to 12 inches and external measurements to 13 inches. ATS calibrations are in accordance to the most recent specification.

External Gages/Standards

Ball Gages, CMM Sphere’s, End Measuring Rods, Mikemasters (Micrometer Master), Surveillance Kits, Master Setting Discs, Thread Measuring Wires, Thread Plug Gages, Special Thread Plug Gages, NPT, NPTF, ANPT Taper Thread Plugs and Taper Thread Rings, Cylindrical Plain Plugs, Pins, Wires, Coating Thickness Standards and any Outside Diameter Gage/Standard within our stated range.

Internal Gages/Standards

Cylindrical Plain Ring Gages, Thread Ring Gages, Special Thread Ring Gages, Snap Gages and any Inside Diameter Gage/Standard within our stated range.

The Standards Lab is environmentally-controlled for high precision measurement capabilities. The lab is controlled to 68 degree F within a span of +/-1.0 degree F and humidity controlled at 30-55% R.H. The lab also has isolation joints in the flooring to reduce any vibration effects. All gages are cleaned prior to testing and are placed in the Standards Lab to stabilize to temperature for a minimum of 24 hours. Applied Technical Services participates regularly in "Round Robin Gage Measurement Proficiency Testing" in accordance with our A2LA Accreditation.

All Calibrations performed include AS Found and A Left Data and are traceable to NIST, The National Institute of Standards and Technology and are performed in accordance to documented and controlled procedures. Our Quality Assurance system complied with the applicable requirements of ANSI/NCSL, Z540-1, ISO 9001-2000, 10CFR50 Appendix B, 10CFR Part 21 and ISO.IEC 17025. Upon request, we can provide calibrations that are accredited to A2LA. You can also be set up on our web based interface, I portal, which gives you access to electronic copies of Calibration Certifications, current asset status, asset history and due date reports for your equipment.

  • External Gages/Standards
  • Ball Gages
  • CMM Sphere's
  • End Measuring Rods
  • Taper Thread Rings
  • Internal Gages/Standards
  • Cylindrical Plain Ring Gages
  • Snap Gages
  • Inside Diameter Gage/Standard

Similar Services