Meet the newest addition to the ATS family: Veracity Technology Solutions
ATS is open and continues to Serve Clients Daily as an essential and critical business supporting critical infrastructure. COVID-19 Preparedness Statement
Contact Form
Contact Form
Gage Calibration
Applied Technical Services (ATS)
/
/
Gage Calibration
You Are Here:
Applied Technical Services (ATS)
/
/
Gage Calibration

Gage Calibration

ATS has the capability to perform gage calibration on a wide range of Setting Standards and Working Gages. ATS has the ability to calibrate classes XXX, XX, X, Y, Z, and ZZ toolmakers tolerances as well as customer’s tolerances with internal measurements to 12 inches and external measurements to 13 inches. ATS calibrations are performed in accordance with the most recent specification.

External Gages/Standards

Ball Gages, CMM Spheres, End Measuring Rods, Mikemasters (Micrometer Master), Surveillance Kits, Master Setting Discs, Thread Measuring Wires, Thread Plug Gages, Special Thread Plug Gages, NPT, NPTF, ANPT Taper Thread Plugs and Taper Thread Rings, Cylindrical Plain Plugs, Pins, Wires, Coating Thickness Standards and any Outside Diameter Gage/Standard within our stated range.

Internal Gages/Standards

Cylindrical Plain Ring Gages, Thread Ring Gages, Special Thread Ring Gages, Snap Gages and any Inside Diameter Gage/Standard within our stated range.

The Standards Lab is environmentally-controlled for high precision measurement capabilities. The lab is controlled to 68 degree F within a span of +/-1.0 degree F and humidity controlled at 30-55% R.H. The lab also has isolation joints in the flooring to reduce any vibration effects. Before performing a gage calibration, all gages are cleaned prior to testing and are placed in the Standards Lab to stabilize to temperature for a minimum of 24 hours. Applied Technical Services participates regularly in “Round Robin Gage Measurement Proficiency Testing” in accordance with our A2LA Accreditation.

All Calibrations performed, including gage calibration include As Found and As Left Data and are traceable to NIST, The National Institute of Standards and Technology, and are performed in accordance to documented and controlled procedures. Our Quality Assurance system complies with the applicable requirements of ANSI/NCSL, Z540-1, ISO 9001, 10CFR50 Appendix B, 10CFR Part 21 and ISO/IEC 17025. Upon request, we can provide calibrations that are accredited to A2LA. You can also be set up on our web based interface, iPortal, which gives you access to electronic copies of Calibration Certificates, current asset status, asset history and due date reports for your equipment.

  • External Gages/Standards
  • Ball Gages
  • CMM Spheres
  • End Measuring Rods
  • Taper Thread Rings
  • Internal Gages/Standards
  • Cylindrical Plain Ring Gages
  • Snap Gages
  • Inside Diameter Gage/Standards

Request Form

Mechanical Calibration Links